Wednesday, December 1, 2010

translate process (Details 1-1/2"/ft and finer)

Focusing on one typical detail the following process evolved - the results match the Revit detail very closely... We will have to see if successive exports have any glitches in them.
Since Revit is exporting in a CAD layer format much like the NCS- the following was translated down to Dustin's template (Fewer layers....) for this project.
#1 Export from Revit (Using the NCS3.0 APPX template and Override objects:
#2 Open in AutoCAD and cleanup using DWG_CLEANUP VBA (I have here locally - we can set to redistribute if needed)
#3 LayerTrans using the attached template: NOTE_ Not all line weights are there- BUT most are... We can adapt further and re-examine if later exports vary too much:

No comments:

Post a Comment